Proportional-current (PC) hydraulic valves and manifolds of the kind typically found on Laser Leveling box blades and other compatible brands. Everything here is priced online and ships from Tampa, FL. Check the compatibility notes below before you order, or call us and we'll help you pick the right part.
Dual Cylinder Control Valve Manifold Assembly
Valve manifold for dual-cylinder box blades and other land-leveling attachments, complete with two Rexroth PC directional valves. Finally, a way to control your dual-cylinder system without jumping through hoops: hook it up, set your speeds, and go to work. Simple, like it always should have been.
Single Cylinder Control Valve Manifold Assembly
Valve manifold for single-cylinder box blades and other land-leveling attachments, complete with a Rexroth PC directional valve. Typically found on Laser Leveling box blades and other compatible brands.
Rexroth PC Directional Valve
The complete Rexroth directional valve assembly, including the cable strain relief and mounting screws. Typically found on Laser Leveling box blades and other compatible brands.
Electrical Rebuild Kit for Rexroth PC Valve
All the hardware you need to replace a broken or corroded electrical box on a Rexroth PC valve. Typically found on Laser Leveling box blades and other compatible brands.
Will it work with my system?
These are PC (Proportional Current) valves. Match them to the output type of your control box:
| PC | Yes. Proportional Current. This is what they're built for. |
|---|---|
| PT | Usually. Proportional Time. They work on most PT setups. |
| PV | No. Proportional Voltage. Don't use them on PV systems. |
Not sure which your system uses? Call us with the make and model of your control box, or send a photo of its label, and we'll tell you.
Electrical specs
- Coil voltage: 12 volts. 9–14 volts is typically acceptable.
- Current: a coil may draw up to 5 amps.
- Undersized wire, a loose connector, or a weak ground drops the voltage at the coil, and the valve responds slowly or not at all. Check those first when a valve acts weak.
Before you install
- Lower the attachment to the ground, shut the tractor off, and relieve hydraulic pressure before you open any line.
- Disconnect power to the control box before you work on valve wiring.
- Keep it clean. Cap open hoses and ports, and wipe fittings before you connect them. Dirt in the oil is a common cause of a sticking valve.
Returns and help
Valve hardware is returnable under our Shipping & Returns policy.
Need help choosing, or a part that isn't listed? Call (813) 390-1062, Mon–Fri, 9–5 ET. Dealers: ask about dealer pricing.
Rexroth is a trademark of Bosch Rexroth AG. Laser Leveling and other brand names are used only to describe compatibility. JTS Labs is an independent supplier and is not affiliated with or endorsed by those companies.